mcarterbrown.com - View Single Post - Connecting a slide-check to a reg?

pk5 · 05-11-2008, 03:46 AM

Hi everyone

So i can't sleep and i am just wondering:

A typical slide check valve look like it have 1/8 NTP threading on both side, on one side is a female, the other side is a male.

Since i have an air america raptor rex regulator and a remote line:

Can i:

Replace the quick disconnect output that is on the air america reg with the male end of the slide check. And connect the female end of the slide check to the remote line in place of where the usual on off would be.

Is this possible? Will it be able to handle the output pressure, which it would have to handle anyway if the slide check is on the other end of the remote.

05-11-2008, 03:46 AM	#1 (permalink)
pk5 Active Member Join Date: Sep 2006 Posts: 183	Connecting a slide-check to a reg? Hi everyone So i can't sleep and i am just wondering: A typical slide check valve look like it have 1/8 NTP threading on both side, on one side is a female, the other side is a male. Since i have an air america raptor rex regulator and a remote line: Can i: Replace the quick disconnect output that is on the air america reg with the male end of the slide check. And connect the female end of the slide check to the remote line in place of where the usual on off would be. Is this possible? Will it be able to handle the output pressure, which it would have to handle anyway if the slide check is on the other end of the remote.