mcarterbrown.com

mcarterbrown.com (http://www.mcarterbrown.com/forums/)
-   Air Gun Designs (http://www.mcarterbrown.com/forums/air-gun-designs/)
-   -   What is the quickest, easiest way to break the feed neck weld on a SS mag body? (http://www.mcarterbrown.com/forums/air-gun-designs/14493-what-quickest-easiest-way-break-feed-neck-weld-ss-mag-body.html)

Steven_Spinosa 04-14-2007 12:51 AM

What is the quickest, easiest way to break the feed neck weld on a SS mag body?
 
I've got a wild urge to tinker. Need help to execute my idea. Thank you!

Brewtt 04-14-2007 01:04 AM

Two words:

Smoke wrench. :hammer:

B 04-14-2007 01:44 AM

There is only one way to break a weld use force. now if you want the easiest ways to remove something welded you can drill the weld, cut the weld with a die grinder or use plasma to cut around the weld.

Allfat 04-14-2007 01:48 AM

I would say grind the weld, then hit it with a hammer.

Steven_Spinosa 04-14-2007 01:56 AM

Hmm... I think I'll dremel around the weld then. I'm going to make a vertical feed hole, so I can just cut widthwise across the top of the body first, using the width of the original neck as a guide, and finally dremel it off by cutting under it.

kidneythief 04-14-2007 03:09 AM

Most mag feed necks are silver soldered on... not knowing which mag you are "customizing" its hard to advise.

-Jake

Steven_Spinosa 04-14-2007 04:34 AM

classic mag SS body.

doc Zox 04-14-2007 08:45 AM

you're not going to break that weld with out nerfing the body

if its silver soldered you could use a torch to heat the neck/body till its red, then it will fall off, but any other parts in the area with the same temper solder could shift too.

Its such a clean union, i would hacksaw off the neck, then file down the remainder.

for a feed neck, you might figure out how to use a stub of a neck as a mechanical fastening point.

Hobbes 04-14-2007 10:48 AM

I had feedneck stuck on a powerfeed body that I just couldn't get off, so I tried to hammer it and knocked the whole powerfeed clean off the body. The body was old/painted so maybe that had something to do with it.

eric 04-14-2007 11:53 AM

ive got a body without a feed neck on it which i just took the rubber mallet to and it came off with a couple hits if you'd like this one give me a shout and we'll workout something cheap ;)


All times are GMT -4. The time now is 05:25 AM.

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO
© MCB Network LLC