Custom

[PumpDrew]

Stanchy doesn't do shaft2+. Anyone else want to?

[PumpDrew]

Nobody?

[rockwings]

The reason they don't do it is because there isn't enough room to punch a hole, it would just go through the piece and wouldn't hold inserts. Shaft 2's cannot be bored for freak inserts.

[super_stanchy]

Originally Posted by rockwings

The reason they don't do it is because there isn't enough room to punch a hole, it would just go through the piece and wouldn't hold inserts. Shaft 2's cannot be bored for freak inserts.

huh?

its thick enough, it just has too much taper to hold it safely and without any runout

[brycelarson]

Originally Posted by super_stanchy

huh?

its thick enough, it just has too much taper to hold it safely and without any runout

this. I have done a couple of PE barrels - the external milling makes them difficult to work on.

[super_stanchy]

Originally Posted by brycelarson

this. I have done a couple of PE barrels - the external milling makes them difficult to work on.

did you do a black etek back?
somebody said i did it and was like uhhhh i dont think i did
i was so confused

[brycelarson]

Originally Posted by super_stanchy

did you do a black etek back?
somebody said i did it and was like uhhhh i dont think i did
i was so confused

I did a blue shaft...3? that might be the only one. It was for a friend - and I warned him it might go badly.

It was fine - but annoying.

I don't think I did an etek.