mcarterbrown.com

mcarterbrown.com (http://www.mcarterbrown.com/forums/)
-   Ask The Experts (http://www.mcarterbrown.com/forums/ask-experts/)
-   -   PGP Valve and cup seal "how to" (http://www.mcarterbrown.com/forums/ask-experts/347-pgp-valve-cup-seal-how.html)

Relic 04-11-2006 11:01 AM

PGP Valve and cup seal "how to"
 
I know this is one of those common questions that probably appears ad naseum on MCB, PGPOG and others, but since they're still down and also due to the fact that it would make a rather lovely sticky here, I'll ask it here as well. :)

I have two older PGP's that I'm replacing the valve assembly and cup seals on, are there any online guides on how to go about doing this?
Are there any brass addicts who can offer any advice or tips on this?
Thanks!

Wharf Rat 04-11-2006 12:14 PM

There's a huge thread on this topic on PGPOG. I dont know when it will be back up, though. P

Walker 04-11-2006 08:24 PM

Try this......

http://www.pbase.com/the_kampfer/dis...ly_walkthrough


Walker

Relic 04-11-2006 10:35 PM

Ahh Sweet! Thank you Walker

Walker 04-12-2006 12:02 AM

Quote:

Originally Posted by Relic
Ahh Sweet! Thank you Walker

My pleasure.....:)

Wharf Rat 04-14-2006 09:55 AM

Four tips not included in that article:

there may be a small set screw with an allen head that goes into the bottom of the lowest tube concealed under the grip frame. It means the gun has had a valve job. It MUST be removed before tapping the valve out of the body or it will destroy the gun's internals. Use something to air seal it when replacing it after the valve is re installed.

If you don't h ave the special steel punch shown in that article, you can drop a used 12 gm in the front of the co2 tube and tap the back of it to drive the valve assembly out. DON'T use any other punch or it may destroy the valve seat. Don't try to drive it all the way through, it won't go.

Throw the lead seal away and don't replace it.

The article shows reassembly with the gun sideways. I find the best way is to hold the tool straight up with the valve components balanced on the top. Hold the gun straight up in the air and slide the assembly in.

P


All times are GMT -4. The time now is 08:55 PM.

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO
© MCB Network LLC