mcarterbrown.com

mcarterbrown.com (http://www.mcarterbrown.com/forums/)
-   Dealers Forum (http://www.mcarterbrown.com/forums/dealers-forum/)
-   -   stripes raised phantom feed (http://www.mcarterbrown.com/forums/dealers-forum/165982-stripes-raised-phantom-feed.html)

Lindsay 06-19-2011 10:42 AM

stripes raised phantom feed
 
http://i252.photobucket.com/albums/h...DSC03060-1.jpg
http://i252.photobucket.com/albums/h...DSC03061-1.jpg
http://i252.photobucket.com/albums/h...DSC03062-1.jpg
there were questions of if a site rail could be made to fit. so i did it.
there is no longer a slot in the rear of the body, just a single hole to mount the body.
http://i252.photobucket.com/albums/h...8/DSC03266.jpg
http://i252.photobucket.com/albums/h...8/DSC03066.jpg
http://i252.photobucket.com/albums/h...8/DSC03245.jpg
http://i252.photobucket.com/albums/h...8/DSC03249.jpg

$135 raw

All pieces will be complete, 2 feed mounting screws & black cci feed gate, also rail screws. holds 13 balls & is raised up off of the body 1/4 of an inch. There are tapped holes on top to mount the stock cci sight rail. Custom requests can be discussed.

pk5 06-22-2011 04:25 PM

How long do you plan on doing these run? I would like 2, but not until grimm release his kit.

dundadun 06-22-2011 04:37 PM

One in raw, with left side ball slots only please, price will determine how soon I can pay :)

Lindsay 06-22-2011 04:48 PM

I can make as many as needed. Left feed only already taken care of for first order.
I am sending one out to someone to try & get a little feedback on it.

Feyd 06-23-2011 07:15 PM

I wonder if that would fit and how it would look on a Duck? Feyd............

pk5 06-23-2011 07:17 PM

Last time we asked it would not fit a duck slide, so are you asking about a redux or a carter?

dundadun 06-23-2011 07:28 PM

duck slides are flat on top right? This is rounded to fit the phantom's sc breach.

Lindsay 06-23-2011 07:41 PM

Don't worry. This feed will fit any gun it is milled for. I will need to see your duck feyd & also a T2. I am making a flat bottom brass one for my brass sniper so a duck is not far off.

Chaos 06-23-2011 08:11 PM

It'd probably fit a Duckslide,but,not without a few tweaks

Lindsay 06-23-2011 08:22 PM

No not without modifying the bottom. But I will do it if people want it.


All times are GMT -4. The time now is 07:13 PM.

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO
© MCB Network LLC