| ||Thread Tools||Search this Thread|
|11-19-2012, 02:02 AM||#1 (permalink)|
I think I'm done for a while. (Mini SC sterling build)
So I have been working on a sterling for a while. Now it's my tiny and smooth stock class shooter instead of my autotrigger machine.
-Body 3D milled for a radius to accept phantom feeds and spyder feednecks
-Custom pump handle
-Custom brass dual pump rod setup
-Custom back block
-Custom delrin bolt(with velocity adjuster)
-Custom valve body(to allow for back block)
-Rethreaded cocking rod(almost 1 in shorter)
-Freak bored and rethreaded phantom barrel
-Phantom feed tube
I was sure to tap both sides of the feed hole to allow for spyder feednecks. That way it can still be my autotrigger machine
|11-19-2012, 10:29 AM||#3 (permalink)|
|11-19-2012, 04:36 PM||#5 (permalink)|
I figured I love the phantom barrel. So, I rethreaded an 8" phantom barrel and now use a .679 insert.
Then the stock pump handle was about the same length as the barrel and I was nearly shooting my fingers. So, I made a pump handle that is about .750 shorter. I then shortened the pump rod about 1" and continued the threads along the larger diameter section.
|11-19-2012, 06:48 PM||#6 (permalink)|
vary nice looking sterling, love all the custom work done on it
The devils Brigade
Its always better with a pump, and camo
|12-25-2012, 06:30 AM||#7 (permalink)|
Join Date: Nov 2007
I gotta KNOW!!!what is the thread for Sterling barrels? I've been trying forever to learn this so I can finish my barrel. BTW Very nice job.
Political Correctness is a doctrine, fostered by a delusional, illogical,
Liberal minority and rabidly promoted by an unscrupulous mainstream media,
which holds forth the proposition that it is entirely possible to pick up a turd by the clean end.
Do we find the cost of freedom
Buried in the ground
Mother Earth will swallow you
Lay your body down
|12-26-2012, 01:26 AM||#9 (permalink)|
I cannot stop coming into this thread and drooling over your sterling..
It is because of you I bought, well after the holidays, am paying for a new sterling body to have milled similarly. I have always wanted that though, so I'm not copying that much, but I am definitely copying the phantom barrel idea. Though, sort of always thought about that as well, just never pursued it since I didn't think or know it was possible.
Now I am reexamining the pump handle and bolt...
|12-31-2012, 05:25 AM||#10 (permalink)|
Question for you sir.
With the stock pump handle, will an 7" barrel be inside the pump handle?
I am getting an 11" phantom barrel rethreaded, and having the stock barrel shortened. I'm just trying to decide which length to get it cut down to. Though, I am considering a new custom pump handle as well, I just dont want to be stuck not getting to use the short one due to the pump handle. Thanks.
|Thread Tools||Search this Thread|