View Single Post
Old 10-03-2012, 10:32 PM   #6 (permalink)
MCB Member
tjd10684's Avatar
Join Date: Jul 2009
Location: Beaver Falls PA (outside Pittsburgh)

OK I will give it a try. another question is there suppose to be a spring holding the power tube oring in place? When I took the brass piece off the tip of the valve their was a spring and an oring in that order. I dont think that makes a good surface for that oring to seal against but is that right?
My Feedback -

A wise man once said:
"The gap between theory and reality is not as far in theory as it is in reality."
tjd10684 is offline   Reply With Quote