View Single Post
Old 04-17-2014, 05:37 PM   #360 (permalink)
MCB Member
tjd10684's Avatar
Join Date: Jul 2009
Location: Beaver Falls PA (outside Pittsburgh)

Originally Posted by delta5 View Post
I searched the thread and didn't find any mention of a Smart Parts Linear. Can you do one of those?
Yes I have done exactly 1 of those before.

Originally Posted by Senator View Post
I did take the time to read through the entire thread and I did not see if anyone had asked if you could bore Shaft 3 and Shaft 4 barrel backs to accommodate Freak stainless steel inserts as well?

Also, as a practical matter, of the barrel backs I have, do I just choose the largest caliber back and send that one for boring?

You just bored out a barrel for one of my teammates and he was very pleased with your work!
Yes so far I can do all eclipse shaft barrels except the SL series barrels since they tend to be smaller on the od.

Yes larger is better.
My Feedback -

A wise man once said:
"The gap between theory and reality is not as far in theory as it is in reality."
tjd10684 is offline   Reply With Quote